2004.5-2007 FORD 6.0L POWER STROKE FUELTEK FUEL INJECTION KIT
This FUELTEK most elaborate kit for your Injector and Oil Rail repair or upgrade project. A set of two high pressure oil standpipes and two oil rail plugs (dummy plug) for the 6.0L diesel. These standpipes are great for preventative maintenance in terms of preventing high pressure oil problems. High Pressure Ball Tubes connects the fuel injector to the high pressure oil rail. All our High Pressure Ball Tubes includes gaskets for a complete repair. This also comes with a 8 sets of External O-ring kit for 6.0L Powerstroke injector, and includes high pressure rail inlet O-ring on the top of the injector. An ICP Sensor Seal goes between the valve cover and the high pressure oil rail where the ICP sensor screws in. Valve cover removal is required for replacement. This is a commonly overlooked gasket when service work is performed.
Kit Includes :
- 2 - Oil Stand Pipe
- 2 - Dummy Plug
- 1 - ICP Sensor Seal
- 1 - ICP Sensor O-Ring
- 1 - Rail Plug
- 1 - Removal Tool
- 8 - Ball Tube
- 8 - O-Rings
- 8 - Fuel Injector Service Kits with Washers and O-Rings
Fits the following vehicles :
- 2004.5-2007 Ford F250/350/450/550 6.0L Diesel Trucks (with build date after 09/22/2013)
- 2004-2010 Ford E-Series 6.0L Diesel Vans.
Note: The Ford 6.0L Stand Tube & Dummy Plug Kit will not work on the early 2004 version of the Ford 6.0L Power Stroke!
**⚠California Proposition 65 Warning: Diesel engine exhaust and some of its constituents are known to the State of California to cause cancer, birth defects, and other reproductive harm.
Visit: www.p65warnings.ca.gov
